Wood-o-floor as Your Reference » You can find three main types of floor structures, generally found in modern construction. Included in these are framed, truss floor surfaces Wood-O-Floor and manufactured joist systems. Of most, the most commonly installed floor coverings system are framed floor surfaces. They consist of dimensioned lumber, bearing on exterior and interior weight bearing wall surfaces or beams called “floor joists”. Usually the floor joists are installed, spaced 16″ aside. Putting in rim and trimmer joists, to which the floor joists are nailed, finishes the perimeter. Bracing, usually by means of bridging, but often installed as strapping, stops the joists from turning in place. One other method used to prevent this kind of making is to glue the sub-flooring to the joists, as the sub-floor is positioned.
derevyannye poly rovnoe i prochnoe osnovanie from Wood-O-Floor, Take it along with you when looking for drapes or any other decorating materials screenshot received from: mukhin.ru.
Wood-o-floor as Your Reference » Truss floors are simply just that. They are simply constructed from small dimensioned lumber, interconnected in a webwork routine by the use of metal or wood plates. Once in a while, the trusses will be built on site, utilizing plywood plates to connect the webwork jointly. Generally they can be installed 24″ aside, either suspended on bearing wall surfaces or beams, or installed with plywood lean or rim joists about the perimeter. Strapping is installed on underneath side, Wood-O-Floor to prevent turning in place, which really is a common condition for deep truss components. Regarding long period truss work, bearing measures of at least 3″ are very common. Trusses span greater ranges than framed floor assemblies and can be made to span the entire building, eliminating centre load bearing aids. They are reasonably more costly than framed floor assemblies, but provide a incredibly strong floor with little deflection or “bounce” to it.
Wood-o-floor as Your Reference » The produced joist, which really is a relatively new product, is often created from low cost materials in the form associated with an I beam, similar to material beams in bigger buildings. What this means is that the joist is designed with a thicker top and underlying part edge, and generally interlocking aspenite vertically spanning between the two. These systems are incredibly strong, often with the capacity of spanning the whole width of the building. One Wood-O-Floor downside is that type of floor requires special hanger systems made for the joists, to permit those to be hung from one another or against beams/bearing wall surfaces. Manufactured joists are becoming a popular floors system, for they are relatively cheap, reduce labour time and provide enough support. However, contractors need to familiarize themselves using its installations, for poor installation can cause severe structural damage to the joists. A good example is a three point, center bearing joist, remaining with the most notable chord uncut, which could fail or take apart, over the guts bearing point.
HOW TO INSTALL WOOD FLOORING OVER TILE + FLOOR & DECOR GIVEAWAY
Wood-o-floor as Your Reference » You will discover three main types of sub-flooring installed to cover and course the floor composition. It really is over this that the finished floor will be set. The sub-flooring types include uncooked sheathing, interlocking and strip. It is applied not only to provide a surface for the inside finishes to be positioned on, but also to avoid twisting or torque makes put on the building. The sub-floor also allows insert sharing within the joist framing system. Often the sub-flooring is glued to the joist work to remove creaking floors and also to avoid the floor joists from turning.